Quote:
Originally Posted by ArakAtak
That honestly makes me very sad
jfc, it's not hard u know, even if u butcher the stripping, at least friggin twist it properly
|
I don’t believe you twist wires that go into a terminal.
So I redid whatever wiring had already been ran and got good finished runs on 2 of the 5 units since those wires were long enough. Sorta hoping it’d be like an example so he can finish. I guess instead of buying a 300ft roll of wire he was trying to buy 30ft for one unit, 40ft for one unit etc and everything came up short.
I told him he’d have to solder/heat shrink the wires on the outside to get the extra length.
Cause there’s no way to junction block or wire nut and keep it water proof.
Later he says why’d you say they were short, he’s a bit annoyed and insinuating. They reach just fine. I’m perplexed cause I didn’t see how. So I walk around the side he’s got these cords from the 2nd floor stretched taught and going diagonal out to the compressor unit. Theyre all shoved up against the cover and it’s all bent and pryed open and ****ed.
By this point i could’ve already have finished the system if it was new in the box and he hadn’t touched it. Already fixed his crushed lines, lines he’d stuffed full of mud trying to shove them through the crawl space etc. The locations for the units was all wrong, the crawl space under the house was too small to dream of running a line set. It’s all mud all around the house etc. like JFC a load of gravel is $60.
I was just helping out cause he has like 5 kids running around and I wanted to help them out and get some heat but at that point it was best to walk away and let him do it himself if he wasn’t going to listen to the stuff I was saying. His yard was just full of junk and circle saws and mitre saws just rusting and sitting in mud.
I think there was some mental illness going on, I seen some rough places before but it was like twilight zone over at that place.
Sent from my iPhone using Tapatalk