Roof technology by Plasmatic - Page 13 - TribalWar Forums
Click Here to find great hosting deals from Branzone.com


Go Back   TribalWar Forums > TribalWar Community > General Discussion
Reload this Page Roof technology
Page 13 of 19
Thread Tools
Edofnor
VeteranXX
Old
241 - 10-18-2020, 10:46
Reply With Quote
Quote:
Originally Posted by lemontw View Post
in 2020 people use tools

ftfy
 
Edofnor is offline
 
Sponsored Links
StapleMammal1
Veteran++
Contributor
Old
242 - 10-18-2020, 10:48
Reply With Quote
For example. See what she is doing? Peeling off the shingles? Had she started at bottom corner, and worked her way up, she would not need that tool to remove the shingles.

http://www.youtube.com/watch?v=cFr5boRRkZg

Pull and peel with the right pressure and you can basically get off a whole square at a time.
(a square is 10'x10' if memory serves me correct.)
 
StapleMammal1 is online now
 
Last edited by StapleMammal1; 10-18-2020 at 10:52..
Edofnor
VeteranXX
Old
243 - 10-18-2020, 10:52
Reply With Quote
i want 2 put my penis inside her vagina
 
Edofnor is offline
 
StapleMammal1
Veteran++
Contributor
Old
244 - 10-18-2020, 10:53
Reply With Quote
same, but skinny chicks always ***** it's too deep. you want a chick with thick ankles. they usually can take it deep no prob. that fat ***** that broke my futon sure as **** did.
 
StapleMammal1 is online now
 
Last edited by StapleMammal1; 10-18-2020 at 10:57..
samUwell
VeteranXX
Contributor
Old
245 - 10-19-2020, 10:26
Reply With Quote
Quote:
Originally Posted by StapleMammal1 View Post
.
(a square is 10'x10' if memory serves me correct.)
Correct.
 
samUwell is online now
 
Plasmatic
VeteranXX
Contributor
Old
246 - 10-19-2020, 13:14
Reply With Quote
I used these. Had the roof and some of the wood off in a day.

Yes, it came off in big chunks. The singles were ok, but the install and wood wasn't.

Flashing under shingles, vents installed upside down, barely any ice shield, rotten wood, etc.

Sent from my SM-G973U using Tapatalk
 
Plasmatic is offline
 
Plasmatic
VeteranXX
Contributor
Old
247 - 10-19-2020, 16:12
Reply With Quote
Took yesterday off, pictures from this morning before the snow and Saturday

Pulled up this stupid piece of crooked wood


Surprise, not a square corner on it. Managed to slip in the ***** clips.


Nothing on this sun room is square or straight. Here's a nice gap near the valley by the ladder. Where the first sheet was rotten.


From there I pulled the sheet off the corner. Had some rot under the drip edge.


Found some surprise gold


Thankfully they were pretty slow from the cold and I managed to hose them all down before they got too frisky.

Check out how high the rafter under my boot is compared to the others around it. They're obviously getting in there between the sheet and face board. I'm not going to rebuild this whole goddamn sun room so I'll cram some gutter apron in there when I can.


Cleaned up and swept out all the carcasses.


Dropped a sheet on there, managed to keep it on the roof without it taking me with it.
Surprise the goddamn corner isn't straight. Sawed off a wedge nearly an inch wide from the bottom up towards the peak.



From there I ran ice shield and paper up under the existing paper near the top and started shingling. Got this done before dark.


Cleaned up and flopped the tarps back down.


Rained yesterday and this morning. Went up and took these pictures before the snow.


 
Plasmatic is offline
 
Last edited by Plasmatic; 10-19-2020 at 16:52..
lemon
Sour++
Contributor
Old
248 - 10-19-2020, 16:17
Reply With Quote
Quote:
Originally Posted by Plasmatic View Post
My roof technology is advancing.

Fml


Sent from my SM-G973U using Tapatalk
you've been working on this for a month

 
lemon is offline
 
Plasmatic
VeteranXX
Contributor
Old
249 - 10-19-2020, 16:59
Reply With Quote
Yep. Fml.






 
Plasmatic is offline
 
samUwell
VeteranXX
Contributor
Old
250 - 10-19-2020, 18:45
Reply With Quote
Damn...
 
samUwell is online now
 
KingSobieski
VeteranXX
Old
251 - 10-19-2020, 18:54
Reply With Quote
Have you considered hiring some $20/hr Craigslist roofing guy to help out?

Sent from my Moto Z (2) using Tapatalk
 
KingSobieski is offline
 
lemon
Sour++
Contributor
Old
252 - 10-19-2020, 19:37
Reply With Quote
Quote:
Originally Posted by samUwell View Post
Damn...
how long would a few of you guys take on this

2 days?
 
lemon is offline
 
Brasstax
VeteranXX
Contributor
Old
253 - 10-19-2020, 23:15
Reply With Quote
Are you trying to snatch defeat from the jaws of victory?
 
Brasstax is offline
 
Plasmatic
VeteranXX
Contributor
Old
254 - 10-19-2020, 23:35
Reply With Quote
Quote:
Originally Posted by samUwell View Post
Damn...
Supposed to be in the high 50's/ low 60's tomorrow. I'll run Ice shield and drip edge where the tarp is over the garage (by the ladder) and see where I end up. Hopefully dry enough by then to finish shingles on the sun room and start shingles over the garage.



Quote:
Originally Posted by Brasstax View Post
Are you trying to snatch defeat from the jaws of victory?
Is this Mason code for something?
 
Plasmatic is offline
 
Plasmatic
VeteranXX
Contributor
Old
255 - 10-20-2020, 18:09
Reply With Quote
Snow was mostly melted by noon

Sent from my SM-G973U using Tapatalk
 
Plasmatic is offline
 
samUwell
VeteranXX
Contributor
Old
256 - 10-20-2020, 18:25
Reply With Quote
Get
that
****
on!
 
samUwell is online now
 
Plasmatic
VeteranXX
Contributor
Old
257 - 10-20-2020, 18:42
Reply With Quote
Got a little rain that turned into a mist, so I stopped after the sun room was shingled. If the weather cooperates I'll be done shingling tomorrow.
 
Plasmatic is offline
 
Plasmatic
VeteranXX
Contributor
Old
258 - 10-21-2020, 23:03
Reply With Quote
Had some running to do this morning, gave it a good chance to dry out.
 
Plasmatic is offline
 
Last edited by Plasmatic; 10-21-2020 at 23:15..
Plasmatic
VeteranXX
Contributor
Old
259 - 10-21-2020, 23:15
Reply With Quote
Todays progress. Built a triangle


Chalk line up the last valley


Really digging the valley technique. Makes for a crisp edge.


Then it started to rain. Heavy for a few minutes


Turned onto a mist, ended up 8 shingles short.




Covered it up with a small tarp and some paper.




Shout out to my cutting board. Maybe I'll frame it.


Storming out now. Picked up another bundle earlier tonight. I'll finish shingles tomorrow after the rain, and do the stupid stink pipe flash and ridges.

 
Plasmatic is offline
 
Brasstax
VeteranXX
Contributor
Old
260 - 10-21-2020, 23:21
Reply With Quote
Hurry up goddammit.
 
Brasstax is offline
 
Page 13 of 19
Reply


Go Back   TribalWar Forums > TribalWar Community > General Discussion
Reload this Page Roof technology

Social Website Bullshit

Tags
real man


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


AGENT: claudebot / Y
All times are GMT -4. The time now is 09:17.