Forewarning: I know nothing about electronics.
I have a Peavey Pro 500 bass head. Tube pre, solid state power.
Sometimes when I power it on, there is either VERY little volume or none. Sometimes I'll play and it will cut out to the same volume. When I hit the switch to turn it off, it goes to the normal volume for a split second then turns off. Usually when I turn it back on again, it works fine.
Repeat.
Any ideas?
I'm not TOO concerned because I'm going to be buying a new amp anyways. But it'd be nice to figure this out so I can at least sell it.
I have a Peavey Pro 500 bass head. Tube pre, solid state power.
Sometimes when I power it on, there is either VERY little volume or none. Sometimes I'll play and it will cut out to the same volume. When I hit the switch to turn it off, it goes to the normal volume for a split second then turns off. Usually when I turn it back on again, it works fine.
Repeat.
Any ideas?
I'm not TOO concerned because I'm going to be buying a new amp anyways. But it'd be nice to figure this out so I can at least sell it.